Hikio Robotics - IOT based Underwater Systems, Applications and Robots
Applications
Underwater ROVs
Store
About Us
Contact
Motor speed control driver circuit board is required to drive M1 Underwater Thruster Motor. It has been specially programmed to make the motors run in 2 directions clockwise and counterclockwise for underwater related applications such as ROVs. This board is required to drive 3 phase motors. Due to its relatively small size, it takes up less space in underwater applications.
  • Seçenek 1
  • Seçenek 2
Product Description
The PWM signal line can be controller with both 3.3v and 5v source. It is further optimized to the perfect drive performance with 32bit MCU controller. Low-voltage protection, over-heat protection and throttle signal loss protection. Separate power supply for MCU and BEC, enhancing the ESC’s ability of eliminating magnetic interference. Parameters of the ESC can be set via program card or transmitter. Throttle range can be set to be compatible with different receivers. Equipped with built-in linear BEC or switch BEC.

It has already been programmed so that it can support 2 directions clockwise and counterclockwise for underwater related applications such as ROVs. Regarding acceleration and deceleration, smooth start and stop are adjusted by the pre settings.
Technical Information
Size: 35x17mm
Input voltage: 7-26 volts (2-6S lipo battery)
Current: 20A
PWM signal voltage: 3.3-5 volts
PWM stop signal: 1500 microseconds
PWM forward max signal: 1900 microseconds
PWM reverse max signal: 1100 microseconds
Weight: 11g
Content
1x ESC